Questions & Answers

Anyone interested in a mapping of maschine studio to control studio one v3?

0 votes
396 views
asked Mar 10, 2017 in Studio One 3 by 1_Lyfe_0527 (2,090 points)
Since last  trying to figure out ways to were i wont have to touch the mouse that much i started building a template for v3.3.4.So far it just has a main page and a second for impact as of right now on the master page you can add buses remove them show instrument even pick the fx you want to load into a console channel.you can open mixer editor sketch pad show instrument of selected channel show fx that are on a channel add sends to selected channel impact is set up to where you can load it and switch to a bank and you are ready to go i havnt done volumes mute ect a i have the cs18 beside it.Im working on it daily just figured i would see if anyone was interested

3 Answers

0 votes
answered Mar 11, 2017 by alanheeren (270 points)
Very interested!  I have Maschine Studio and a CS18AI as well!
0 votes
answered Mar 11, 2017 by 1_Lyfe_0527 (2,090 points)
Ok like i said its a work in progress i will send it in the morning once i get everything up and running.I am open to all suggestions once you get it and any feed back good or bad.Since i have the cs18 beside it i didnt waste time with the transports imtrying to set it up where the cs18 leaves off.Isthere anything that comesto your mind you would like it to do i will try and implement what i can before i send it to you.
0 votes
answered Jan 21, 2018 by djkidstretchwarriorzrecords (1,440 points)
Any chance you can share this template? I'd love to test it! :)
...