Questions & Answers

Why do I have to reboot (power cycle) the console in order for it to show up in UniversalControl?

0 votes
1,057 views
asked Apr 3, 2018 in StudioLive Series III by bradleonard1 (2,160 points)
I have this issue with both a Studiolive Series 3 24r and my StudioLive Series 3 32. When the mixer is connected a standard wifi router I have to reboot the mixer so that it will show up in UC on any device (Windows, Mac, Android, iOS both wired and wireless devices). What am I missing here? The router has handed out an IP address to the mixer, it can be pinged, what is the causing the need for a power cycle? This seems to happen whether the router was powered on first or after the mixer.

2 Answers

–1 vote
answered Apr 4, 2018 by johnbagga (420 points)
selected Jun 25, 2018 by benpierce
 
Best answer

Rebooting is very much necessary to console to get the command from the C drive files that users want to excess that files in the system. Many times these kinds of problems occur in Windows 10. Then what users can do is simply ping at Windows 10 get help and they can get the best response from their side according to the queries they ask to them at the time of when they face any kind of problem in their operating systems.

0 votes
answered Dec 23, 2020 by jameswillian (140 points)

If you are facing any software issue, dead issue, IMEI issue, and boot loop issues in your smartphone, you can use a firmware file to fix all the issues. It contains the operating system of your device in its unique form. 

...