Question

Presently, when Series III mixer is in slave mode, i.e., clock is Network derived, there is no indication to show the clocking status of the NSBs.  If  there's a clocking error, there's no way to check except thru the Master console.  This is inconvenient for diagnostic purposes.  Should only require firmware update.

Answer 1

Thank you for the feature request. 

If anyone else agrees or disagrees, please VOTE!

The developers pay close attention to those that are voted on the most. 

You are allowed one vote. You can change your vote later if you choose.

(Here's some helpful info on how to use the voting system)

Please vote the original question / feature request. 

Please DO NOT Vote on THIS response!