Question

Right now in Studio One, if you need to copy from one track to another a compressor that's already set up for sidechaining, you get all the original compressor's settings except that you have to enable the sidechain button again, and then switch back to the sidechain source and set that up with an additional send.  

This is all a waste of time.  Studio One should be smart enough to set up the compressor's copy as sidechained, look at the source of the original compressor, go to that source, and automatically create a send at the same volume as the original.  Why should the user have to recreate all this if all the needed information is already available?  If this is considered problematic, ask the user for confirmation to generate the additional sidechaining source/target setup.

Answer 1

Thank you for the feature request. 

If anyone else agrees or disagrees, please VOTE!

The developers pay close attention to those that are voted on the most. 

You are allowed one vote. You can change your vote later if you choose.

(Here's some helpful info on how to use the voting system)

Please vote the original question / feature request. 

Please DO NOT Vote on THIS response!