Questions & Answers

Xpand2 and S3 - Multiouts not working

0 votes
asked Nov 30, 2017 in Studio One 3 by trumpet (120 points)
Hi all,

I have a Firestudio project running on Windows 10. I got Xpand2 from and downloaded and installed the product. I usually don't download stuff like this, but I saw the same article on presonus expert and then decided to go in for it.

The product works flawlessly but for one issue. The UI loads up showing 4 MIDI channels, I am able to access all 4 channels, assign different patches to all 4. S3 also helps in routing the 4 channels as different MIDI tracks.

BUT, in the inspector panel S3 only shows one output channel which means all the 4 MIDI tracks from Xpand go through this one channel into S3. End result is that I can individually control volume. If I do, all 4 tracks adjust parallel. In the UI it shows the 4 MIDI channels as Part A,B,C,D.

Is there a workaround this? I'd like to get to the bottom of this because Xpand2 is such a good VST.

1 Answer

0 votes
answered Nov 30, 2017 by grimeyneedle (3,570 points)
XPand only has one output.