Questions & Answers

Studio 192: audio output 1-4 muted unless using speaker management: how to get past this

+2 votes
629 views
asked Jan 16, 2018 in Studio 192 USB 3.0 Interfaces by dehendrikwillekens (300 points)

QUOTE from point 4: *** NOTE: Leave Speaker Management to OFF. If you select any other choice and "then" back to OFF, this will "MUTE" Mix 1/2 and Mix 3/4, which could explain why your Line Outputs 1-4 will not pass audio.

How do I get back to a situation that I can decide what to send to Line Outputs 1-4?

I was using Studio One, and have two stereo signals routed to Outputs 1,2 and 3,4 via Two Stereo Sends. It worked.

After trying out Speaker Management, I can't make it work again. The send receive sound but don't seem to send it to the speakers.

Kindly,

Hendrik

related to an answer for: Output 1 to 4 won't work, but 5 to 8 does

1 Answer

0 votes
answered Aug 6, 2020 by arthurzatarain (1,720 points)
I wasted a few hours today trying to figure out why I had no output from lines 1-4. I wasn’t aware of the mute issue. I eventually tried Line 7-8, which worked, so I assumed lines 1-4 were defective. I don’t understand the problem or the solution. I can get by with Line out 7-8 but I would like to understand what is going on under the hood. I see the meter bouncing in S1 but no audio on the outputs. What is going on?
...