Questions & Answers

Side chaining based on incoming frequency

0 votes
372 views
asked Jun 1, 2018 in Studio One 3 by martyc1 (1,830 points)

I miss this option from another DAW.  If I have a percussion bus being used as a side chain signal, I only want freqs below 200Hz to kick off the side chain.  Is there a workflow in S1 to do the same?

1 Answer

0 votes
answered Jun 1, 2018 by TechSupport77 (195,970 points)
 
Best answer

To achieve what you are trying to do, you can set up a bus, add Pro EQ to that bus, set your low pass filter as desired, and then send your audio to that bus.  Once it hits the bus with the filter, you can then add the sidechain compressor to the bus.  Below is an image that illustrates this.  

...