Questions & Answers

Solo bus has no signal. How do I fix this?

0 votes
282 views
asked Jan 22, 2022 in StudioLive Series III by gregsmith50 (290 points)
Could someone explain how the solo button(s) work.

What I want to do is use the solo button as a sound check in the headset but on all of the various options for the solo bus.. I either get every channel on the solo bus or the bus is dead.

StudioLive Series III 32

What are the correct settings?

1 Answer

+1 vote
answered Mar 1, 2022 by robertweston2 (4,170 points)
selected Mar 4, 2022 by mackjohnson1
 
Best answer
1.  Select "Edit" in the Monitors section of the Master control area (bottom right side of the master control section)

2.  In the Monitor Edit screen, select "Solo"

3.  Select "Edit" in the Solo section (just below the Monitors section)

4.  There are a few settings, but the most common are: Set "Latch",  and "Pre Fade Listen".

Now, you can use the Solo button on one or more channels at the same time.  All soloing will be PFL.  Adjust monitor head-phones as needed.  Also, you may need to adjust the "Solo" volume level (the Solo section) up a few db.

I did a video on this some time ago:



Hope this helps.
...