Question

Dear all,

Since new firmware on studiolive 32 SC , when i switch on the mixer i have no audio on inputs and outputs.

To activate the audio i have to recall a scene and after that all back to normal.before it was not the case after a switch off and on the mixer took the last config.the mixer was ready immediately now i have to upload a scene.strange ...

all comments are welcome

Regards

Answer 1

Chances are your Project/Scenes have errors in them. 

I've wipe the mixer clean and re-test. If the issue is no longer there, then setup the mixer again and dis regard your older project/scenes. 

Factory Reset - FX Key - Wipes all user data from the mixer.

Link: https://support.presonus.com/hc/en-us/articles/115001731123-StudioLive-Series-III-Console-Factory-Reset