Questions & Answers

Automation trim and point move with mouse scrool

+1 vote
asked May 15, 2021 in Mixing by siniablagus (2,850 points)
Hi, it would be great if we could move selected automation points with mouse scroll as well, and also when using trim option with smart tool...and with this also to move in small increments while holding shift. Sometime it is easier to do this things with mouse wheel (or maybe even with up/down keys - this would be great when trackpad is used on the laptop, it is hard to be precise with least for me) rather that draging with mouse.

Thank you!

2 Answers

+1 vote
answered May 21, 2021 by StuBabe (1,140 points)
There is a key command that you can assign for this purpose.  Nudge up/down will move the point in increments of 10, and nudge up/down fine by 1.
0 votes
answered May 21, 2021 by siniablagus (2,850 points)

Thank you, this works for the points, I will use this for sure! However, it would be great if it worked for the trim tool as well, I use that a lot when doing automation.

Also, it would be great if it could be done with a mouse scroll wheel as well...