Questions & Answers

Reamping using Studio 192?? Outputs don't send any signal!

0 votes
asked Jul 14, 2016 in Computer Based Recording & Production by simon.jas (150 points)
I have a Studio 192 interface and need to use the unused outputs for reamping, however, the outputs send either no signal at all, or feedback that will only stop when the UC mixer is bypassed. I have a previous Firestudio project that I have used for reamping lots in the recent past and had no problems assigning outputs for that purpose. Any help would be great, I have no interest in keeping the interface if this is going to be an issue in the future, but I would rather make it work since I like everything else about this interface!

I am using an iMac 27" from late 2013 software version 10.11.5 in Logic Pro X version 10.2.4 with Universal Control AI latest version, (just installed and updated a couple days ago).

1 Answer

0 votes
answered Jul 14, 2016 by ryanmiller13 (18,150 points)
Best answer
To assign specific tracks within a song, you would need to bypass your UC Surface mixer and utilize the routing within your DAW to send to the appropriate output in which you would like to reamp with.  Hope this info helps!