Questions & Answers

Legacy StudioLive 16.4.2 No Audio after PC rebuild

0 votes
690 views
asked May 15, 2017 in Classic Mixers by DonaldLang (190 points)
I have recently rebuilt my PC after a motherboard failure. I have installed a compatible PCIe 1394 firewire card with a fully compatible TI chipset and loaded the 1394 legacy firewire driver. When I connect my PC to the board via Universal Control I can control the board, factory reset etc all works fine but I get no audio at all. Smaart tools all silent, youtube wont play, StudioOne wont play back. If I change the PC sound to the rear output Realtek Hi Def Audio the PC will play sound again, Studio One works correctly etc.

The Board is on Firmware 150a build 190 and universal control is 4.2.1.46437 5773. I have tried all of the firewire drivers (TI and the new 1394) and they don't work either.

If I swap to my MacBook using the same firewire cable it all works fine. What have I missed ??

Here is the OHCI info

OS: Microsoft Windows Version unknown  [6.2.9200]
  CPU(s):
    Processor:  Intel(R) Core(TM) i7-7700K CPU @ 4.20GHz
    Physical:  1
    Cores:     4
    Logical:   8
    L1 Cache:  32 KB   (8)
    L2 Cache:  256 KB  (4)
    L3 Cache: 8192 KB  (1)
  Installed RAM: 32698 MB
  Microsoft ohci1394.sys [6.1.7601.22699]
  Microsoft 1394bus.sys  [6.1.7601.22699]

Looking for OHCI 1394 Host Controllers...

Done

2 Answers

0 votes
answered May 15, 2017 by DonaldLang (190 points)
Hi butchrichard thanks for your very concise set of instructions, I followed them to the letter and unfortunately it is just the same, for good measure I went through the process for each of the 3 firewire drivers I have on my machine but alas no joy with any of them.

Very mysterious

Thanks

Donald
...