Question

In order to operate the StudioLive 16.0.2 USB in a midifile-automated environment, I have the following question:

The mute function for FXA or FXB can be switched by a CC. So the state changes between On and Off for incoming CC. However, since no CC value is defined for On or OFF, this function can be confused manually with automated switching through a file. Would it be possible to get a defined switching state in an update of the StudioLive when sending a defined CC value or value range (eg value 10-20 =On; value 90-100=-Off)? For the users of the "midi-footpedal variant", ie the transmission without these specific values, everything can remain the same, the switch between just on / off.

Background: I use midifiles for setup control. At song start and song end a mute must be sent, in between FX are automatically switched on. Sporadic stops with the necessary manual mute, which sometimes occur, would negate the undefined chain of command if you forget to switch back manually. So the possibility of use would also be extended.

Answer 1

Thank you for the feature request. 

If anyone else agrees or disagrees, please VOTE!

The developers pay close attention to those that are voted on the most. 

You are allowed one vote. You can change your vote later if you choose.

(Here's some helpful info on how to use the voting system)

Please vote the original question / feature request. 

Please DO NOT Vote on THIS response!