Question

I was in a session working away, then notice my "Sends" on each of my channel strips were gone. "Insert" are there, but no sends.  Did I hit something that made them disappear?

Thank You!

Answer 1

The answer below by Presonus is incorrect. This does not reveal the sends. I have searched high and low and by mistake discovered how to get SENDS back. You move your mouse/trackpad to the line just above the PANNING section in the channel strip. Click and hold down, then move the mouse up, and it will pull up the SENDS.

Answer 2

My sends are missing too.  They were there when I opened up a new song.  Added FX busses and went to dial in some compression on a send on a track and WTF?! They are gone!! I'm trying like hell to get them visible again and I've tried all the tricks from the past and it's not working.  

Answer 3

View->Console

In the lower left of the console you will see an icon consisting of two arrows, one pointing up, the other pointing down.

Click on that icon.
On each of your track controls in the console, right next to the slider, you will see an icon consisting of two rectangles, one lighter than the other.
Click on that icon, and your inserts and sends will appear to the right of the track.

Answer 4

Sorry I'm that late but I'm gonna answer anyway for others searching for solution. Open console, click the wrench icon in top left (above buttons toggling view of inputs, outputs etc.), in Channel Components there's Sends/Cue mix option. Select it and sends should appear. Just try a few times if didn't work.

Answer 5

Go to Mix,

left side you can see the setting icon

press the icon

give tick mark in "sends/cue mix"

Answer 6

Per michaostrowski above - this click the wrench (YES!), click the sends button

Answer 7

Ik have the same problem. What can i do?

I tried some of the suggested solutions, but it doesn't work. Sometimes with another song, I see send again, but that is mainly a coincidence. In short, arbitrariness.
Also checked the key on the left, where I also checked send, but even then it doesn't help. Could it be that I sometimes have my S1 on a small screen and sometimes on a very large screen. Please advise.
Greeting Henk

Answer 8

There are two instance where you may be not be seeing the sends. One has already been answered (wrench > check Show Sends / Cue Mix) however there is another instance where you have that option checked and the only way to see the sends is to click on the expand icon.

 

If this is what you're seeing then go to the bottom of the mix window and click on the UP/DOWN arrow.

Answer 9

select the track you want to see the sends for

click the inspector icon

it should show on the left