Question

Hi

I have some issues with daw mode on my studio live s3 24 and studio one 4 under win10.

I have the lastest firmware and all work fine with studio live 3.5. But with studio live 4, the transport only work and not always.

The studio live see the soft under ucnet config, it indicate the good daw (SO4) but i didn't see any track on studio live when i activate the daw mode.

anyone have a solution for this problem?

Thanks by advance.

Answer 1

Same here. I have to restart the console (audio interface) then everything gets synchronized fine. If S1 v4  is already open when I start my board there's no problem...

Answer 2

thanks for your answer. i have tried and nothing change. It seen connected but nothing on desk's screens, the daw mode is still empty :/

Comments

There's a lot that could go into having a problem with DAW mode. Some PC's may require that you disable the network port and then re-enable. This could also potentially be an antivirus issue blocking proper communication between the mixer and your computer.

If you're having trouble with connecting to Studio One to use DAW mode your best bet would be to submit a support request so that tech support can gather more information to help you.

Answer 3

I read in the one of the Update Notes, may have been for a firmware update, or StudioOne upgrade, that DAW mode is not functional in Studio One 4. I can confirm it does not operate at all  with my SL24 Series 3 and S1-4.