Question

Hello there. I have a Firestudio Lightpipe. I updated from High Sierra to Mojave, and I saw on this page (https://www.presonus.com/products/FireStudio-Lightpipe/downloads) that I could work it out. But then, after rebooting and installing the Universal Control, I have a blank space at the Clock Source line on the software and on the interface, the light of the clock won't stop blinking (the firewire).
I tried to uninstall and reinstall, to change the firewire port (I checked the ports too), to turn it off and wait, but nothing worked.

Maybe it's not very stable on Mojave jet and it's better to get back to High Sierra?

Thank you for answering, I'm desperate!

Answer 1

I have the same problem with Studio 192. Set to ADAT input and unable to change. Also unable to run without an ADAT source connected.

Answer 2

Has your problem been solved? After upgrading to OSX Mojave everything worked fine until i used an external converter and clocked studio 192 Mobile to it. Now the interface is unable to run on its own and the system doesn't recognise it.

Answer 3

Hi guys, im having the same problem.

did you manage to fix?

thanks

ben

Answer 4

Hi all,

Same/similar issue here.

FYI: My 192 Mobile was giving cliks and pops when I added an extra 8 channels via ADAT/lightpipe ... the solution to that was to change the clock source to ADAT, but then the clock source option went blank and I was stuck at 44.1.  Oddly, it works as is, but I have to have both devices connected now and I'm stuck at 44.1.   I did try several variations of uninstalls, port changes, etc.  Only idea I have left is to uninstall/reinstall Universal Control while ADAT devise is disconnected.. Then if successful, I'll start going back towards my preferences vs just what works.

Thx