Question

I would like to add a pair of SL328AI speakers as side fill speakers. I am anticipating the need to set up a delay. (I am currently using a 32.4.2AI mixer FOH connected via ethernet to AVB to RM32AI operating in stage box/monitor mode. My mains are 2 18sAI and 2 315AI pole mounted above the subs. I have 2 328AI and 2 312AI speakers as floor wedges.) My thought is to use AUX 15/16 of the RM32AI and the delay wizard to set this up, but am concerned that in my current configuration, AUX's 13-16 are actually for sub 1 and 2 from the 32.4.2AI.

How do I set up my delayed side fill speakers?

Answer 1

Well, you can only put them on an Aux or a Subgroup on an AI console. On an aux, it could be pre or post fader. On a subgroup, it would be post fader only.

Answer 2

My situation was exactly the same, but I was not using PreSonus PA gear.
I did what you suggested.
I set my delay speakers on aux 15-16 on the rack mixer and used sub 1-2 on FOH. I used smaart delay wizard to set up the delay time.

Don´t forget to route audio to sub 1-2 on all channels as to mains.

On sub 1-2 don´t route audio to main.

As for subwoofer I used aux 14-15 and set them up to post fader. The other option is to use PA processor as DBX PA2 an feed your subwoofer from the processor