Questions & Answers

Make Macro Controls Curves Easier to Read with a Numerical Display

+7 votes
597 views
asked Mar 10, 2018 in Look and Feel by robertgray3 (42,810 points)
edited Apr 2, 2018 by robertgray3
It would be useful if the Macro Controls Transition Curve editor had a readout of the start and end values.

Something as simple as two numbers displayed below the curve on the left and right would be helpful.

Here's an example of what this could look like. I used this parameter as an example because when editing the curve for this parameter there's very little indication as to where any values between 20 hz and 2.0 khz are since that area is entirely blank on the display. Also, it might be easier to read two larger-text numbers at the bottom than estimate where you want to land on a small graph with small numbers.

2 Answers

0 votes
answered Mar 23, 2021 by Lukas Ruschitzka (261,010 points)
 
Best answer

Thank you for the feature request. 

If anyone else agrees or disagrees, please VOTE!

The developers pay close attention to those that are voted on the most. 

You are allowed one vote. You can change your vote later if you choose.

(Here's some helpful info on how to use the voting system)

Please vote the original question / feature request. 

Please DO NOT Vote on THIS response!

+2 votes
answered Mar 11, 2018 by niles (54,650 points)
...